Fixture for servos of webcam used for Robotics

(1 review) Write a Review
0.20 LBS
Calculated at Checkout

Product Overview

This is a fixture for servos of webcam used for robotics. The picture shows a complete set including the camera.

Note: The servo and camera are NOT included.


The following are sample applications:


LinkSprite WiFi controlled Rover.



To assembly the servo controlled webcam, you will need servo, which can be ordered from:


(1 review) Write a Review

1 Review Hide Reviews Show Reviews

  • 3
    not so easy to assemble

    Posted by Mickey on 13th Oct 2014

    My plan was to use the PCduino camera and not the intended USB camera but that would not effect the issues i ran into. i was moderatly put off. I had to hunt till i found the $25 kit to find any assembly instructions. NONE are included and the ones found were very basic. The groove the servo mounting flange goes in was too tight and i had to file the length and width of the motor flange to install the vertical axis motor. The mounting points for the servo horns do not fit any of the horns that come with the SG90 servos. You will have to carve them down and make them fit. The screws that go thru the horn and into the end of the motor shaft to secure the horn were too small on diameter to catch a thread, fortunately i had screws left over from another motor to replace them. Once I got it assembles it does work. Basic Instructions?