Close

Site Information

  • Image 1

Papilio One 500K

$65.00
SKU:
PAPILIONE_500_E14
Weight:
0.30 LBS
Shipping:
Calculated at checkout
Quantity:
CURRENTLY OUT OF STOCK. CHECK BACK LATER.

Product Description

Butterfly One (Papilio One) board fully assembled with a Xilinx XC3S250E and 4Mbit Atmel SPI Flash memory. 

Easiest way to get started with the Arduino IDELogic Analyzer, andXilinx WebPack applications.

For more information visit the Butterfly One support page. 

Specifications

  • Power
    • Four independent power rails at 5V, 3.3V, 2.5V, and 1.2V.
    • Power supplied by a power connector or USB.
  • USB
    • Two channel USB connection for JTAG and serial communications implemented with FT2232.
    • EEPROM memory to store configuration settings for FT2232 USB chip.
  • Spartan 3E FPGA
    • 32MHz oscillator that can be used by Xilinx's DCM to generate any required clock speed.
    • VTQFP-100 footprint that supports Xilinx XC3S100E, XC3S250E, and XC3S500E parts.
    • Bank 0-3 can be jumpered to support 1.2V, 2.5V, or 3.3V.
    • Xilinx JTAG header supports Xilinx JTAG cables.
    • Power and I/O are routed to the side headers.
    • Board can be used with Bread Boards if only the outside row of the side headers is populated.
  • Wings
    • Easily add new functionality to the Papilio One with Wings that snap onto the board.
    • 48 bidirectional I/O lines which can be split up as:
      • 1 - 32 Bit Wing or
      • 3 - 16 Bit Wings or
      • 6 - 8 Bit Wings

 

Documentation

Downloads

Tutorials

How to move PWM pins
With the flexibility of an FPGA your PWM outputs don't need to be restricted to a specific pin. In fact, Wingsare a snap to develop because they aren't constrained by the board they connect to. With this freedom it is possible to write a sketch that uses a PWM on any pin! This tutorial shows the steps needed to move a PWM output from the AVR8 soft processor to any physical location on the Papilio One board.
  
Full Tutorial


Ordering Note:
The Papilio One does ship with the headers populated.


This open source hardware and software is distributed in the hope that it will be useful, but WITHOUT ANY WARRANTY; without even the implied warranty of MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. If you can't accept this risk, please do not buy this hardware.

Product Reviews

Write Review

  1. The new batch has the headers

    Posted by Guest on 20th Jun 2014

    The new batch has the headers

  2. mine came with headers

    Posted by Unknown on 19th Jun 2014

    Ordered the headers they said, enough for the wing they said.

    I ordered the headers as mentioned in the ordering info of the product description THINKING I WOULD NEED THEM. SURPRISE, THEY ARE ALREADY SOLDERED ON, EXTRA PARTS THAT I NOW OWN.

    contact me for explaination or change the information on the page.

Find Similar Products by Category